DVSA Statistics
1975 Austin Maxi 1750
MOT Pass Rate & Pre-MOT Checklist
There isn't much MOT data yet for the 1975 Austin Maxi 1750 (only 2 tests in our DVSA dataset), so these figures are a rough guide. We still highlight common failure items below so you can check before your MOT.
Pass Rate
Based on 2 DVSA anonymised MOT tests · About this data
Pass Rate
50%
Lower than average
Limited data available for this model; results may be less representative.
Top Failure Reasons
Common MOT failures for this model
Parts Available
Brakes are a common wear item.
Based on DVSA statistics from 2 recorded tests.
Pre-MOT Checklist for 1975 Austin Maxi 1750
Based on common failure points for this model, check these items before your MOT:
- 1
Listen for knocks or clunks when driving over bumps - bounce each corner
Suspension – Common fail on this model
- 2
Ensure engine is at operating temperature before test - take a good run beforehand
Emissions – Common fail on this model
- 3
Ensure all doors open and close properly and latches engage
Bodywork – Common fail on this model
- 4
Test brakes for effectiveness, pull, and unusual noises when driving
Brakes – Common fail on this model
- 5
Check for excessive play in steering wheel - should be minimal free movement
Steering – Common fail on this model
Do you own this car?
Check your specific vehicle for outstanding advisories or recalls. Get a personalized risk report for your exact Austin Maxi 1750.
Frequently Asked Questions
Is a 1975 Austin Maxi 1750 likely to fail its MOT?
Based on DVSA statistics, the 1975 Austin Maxi 1750 has a 50% MOT pass rate. This is below average, so extra pre-MOT checks are recommended.
What are the most common MOT failures on a 1975 Austin Maxi 1750?
The most common MOT failure reasons for a 1975 Austin Maxi 1750 are: a suspension pin, bush or joint excessively worn, emissions levels exceed default limits, a door will not open using the relevant control or close properly. Many of these can be checked and fixed before your test to improve your chances of passing.
How can I reduce the chance my 1975 Austin Maxi 1750 fails its MOT?
To improve your chances of passing, check the items that commonly fail on this model: a suspension pin, bush or joint excessively worn, emissions levels exceed default limits, a door will not open using the relevant control or close properly. Use our pre-MOT checklist above to identify potential issues before your test. Many common failures are easy DIY fixes.
How many 1975 Austin Maxi 1750s fail their MOT?
Around 50% of 1975 Austin Maxi 1750s fail their MOT test, meaning roughly 1 in 2 don't pass first time. The most common reasons are a suspension pin, bush or joint excessively worn and emissions levels exceed default limits. Pre-checking these items can significantly improve your chances.
What should I check before my 1975 Austin Maxi 1750 MOT?
Before your 1975 Austin Maxi 1750 MOT, check these commonly-failed items: a suspension pin, bush or joint excessively worn, emissions levels exceed default limits, a door will not open using the relevant control or close properly. Most are visual checks you can do at home – look for worn tyres, test all lights work, and check for obvious damage or leaks.
Is the 1975 Austin Maxi 1750 reliable for MOT?
With a 50% MOT pass rate, the 1975 Austin Maxi 1750 performs below average compared to typical vehicles. Extra attention to pre-MOT checks is recommended for this model.